Download Sharp AL-1043 Service manual
Transcript
10) Enter the IP address, subnet mask, and default gateway. 10) Select "LPR (TCP/IP) direct printing" and click the "Next" button. The settings in the above window are examples. Be sure to ask your network administrator for the correct IP address, subnet mask, and default gateway to be entered. 11) The printer or printers connected to the network will be detected. Click the printer to be configured (the machine) and click the "Next" button. Note: When "Get IP Address Automatically" is selected, the IP address may at times change automatically. This will prevent printing. In this event, select "Assign IP Address" and enter the IP address. 11) Click the "Next" button. 12) Click the "Yes" button. Go to step 11. Note: If the machine's IP address cannot be found, make sure the machine is powered on, make sure the network cable is connected correctly, and then click the "Search" button. 12) In the window for setting the destination print port name, make sure that ":lp" appears at the end of the IP address and click the "Next" button. LPR (TCP/IP) direct printing After step 1-7. 8) Click the "Printer Driver" button. If you have not set the IP Address, click the "Set the IP Address" button in first and go to step 8 on "Connecting a USB cable". Note: Any name can be entered in "Printer Port Name" (maximum of 38 characters). 13) A window appears to let you check your entries. Make sure that the entries are correct and then click the "Finish" button. If any of the entries are incorrect, click the "Back" button to return to the appropriate window and correct the entry. 9) Read the message in the "Welcome" window and then click the "Next" button. AL-1661CS UNPACKING AND INSTALLATION 5 - 7