Download Seagate ST3400071FC User`s guide

InForm OS Version 2.2.4
Command Line Interface Reference
RESTRICTIONS
■
Functionality of this command requires the 3PAR Remote Copy license. Contact your local
service provider for more information.
■
If the mirror_config policy is set and the setrcopytarget command is issued with the
pol subcommand, the duplicated configuration commands cannot be issued on the
secondary. Doing so results in an error.
■
The name and tput subcommands cannot be used on a target with started groups.
■
There must be an active connection between the systems in the Remote Copy pair to issue
commands on the primary to be mirrored to the secondary. If there is no connection, the
commands return an error.
EXAMPLES
The following example turns off configuration mirroring from InServ1 to InServ2, where
InServ2_out is a secondary target on InServ1 that points at InServ2:
On InServ1:
cli% setrcopytarget pol no_mirror_config InServ2_out
NOTES
■
The setrcopytarget command requires the groups associated with it be stopped prior to
using the following options:
◆
setrcopytarget name <new_name> <target_name>
◆
setrcopytarget tput <throughput> <target_name>
The setrcopytarget command with the following arguments can be run without
bringing down its Remote Copy groups:
■
◆
setrcopytarget pol <policy> <target_name>
◆
setrcopytarget tunelinks <bandwidth> <latency> <target_name>
Under normal operating conditions the mirror_config policy should never be changed
to no_mirror_config. This policy option is included only as a method to correct several
unusual error conditions that might occur in the course of operation which result in a
mismatch in configuration between the two sides of a Remote Copy pair. For instance, it is
possible for a group to be created, or a volume to be added to a group, only on one side of
the pair if the operation is interrupted by a network failure. In such cases it might be
21.59