Download Adaptec APA-358 Installation guide

Transcript
Caution: If you disconnect your SCSI
device(s) from the MiniSCSI EPP while in
use, the adapter loses power and cannot recognize the device(s) when reconnected.
Reboot your computer in this case.
Connecting the Printer
Connect a standard parallel printer cable to the
MiniSCSI EPP printer passthrough connector if you
wish to simultaneously use a parallel printer with
your MiniSCSI EPP. No special configuration or
switching is needed to use your printer.
For U.S. Residents Only: Use the printer cable
included in your kit to connect the MiniSCSI
EPP to your printer. This cable is shielded to
comply with FCC-mandated requirements
for a Class B computing device. Use of any
other printer cable may result in noncompliance with FCC shielding requirements and
undesirable electronic interference with
other devices.
The printer port on the MiniSCSI EPP functions only
while it is powered up; if you disconnect or turn OFF
the connected SCSI device, the printer passthrough
port on the adapter cannot function.
Completing the Installation
1 Turn ON the power for the PC and device(s).
2 Load the software as explained in the Software
User Guide.
In most cases your PC, MiniSCSI EPP, and peripherals are now ready to use.
6 Troubleshooting
If you have a problem during installation, check the
items below. Be sure to read the Troubleshooting section in the Software User Guide for other remedies.
6
A
AAAA
AAAA
AAAA
A
AAAAAAAA
AAAAAAAA
AAAAAAAA
AAAAAAAA
AAAAAAAA
AAAAAAAA
AAAAAAAA
AAAAAAAA
AAAAAAAA
AAAAAAAA
AAAAAAAA
AAAAAA
AA
A
AA
APA-358 Installation Guide
A
AA
A
AA
A
AA
Part
Number:
510604-00,
Rev.
A
A
AA
A
AA
A
AA
Print
Spec
Number:
492717-00
A
AA
A
AA
A
AA
Current
Date:
5/19/94
ECN
Date:
5/31/94
A
AA
A
AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA
AA