Download Cruizer SmartYield

Chapter 6
Setting the Harvest (Wet) Moisture Content
If a moisture sensor has been installed on the combine, the harvest moisture value is calibrated via the
‘Moisture Correction Factor’ displayed on the ‘Crop Select’ screen. Refer to the Moisture Correction Factor
section on page 36 for more information.
If a moisture sensor has not been installed, the harvest moisture content must be manually adjusted on the Info
screen. Touch the Info tab along the right side of the SmartYield display and use the up or down arrows
adjacent to
Moisture Content
Set Harvest Moisture Content
Select Part (current job) or
Total of all jobs since last reset Reset Totals
Set Quantity Readouts based on
harvest moisture (WET) or storage
moisture (DRY) content
Setting the Harvest (Wet) or Storage (Dry) Weight Readout
The harvest, or wet, yield and weight totals are calculated using the moisture content entered by the operator
or measured with the continuous moisture sensor.
The SmartYield system calculates the storage, or dry, yield and weight totals using the moisture content values
set during the harvest operation. Touch the ‘WET/DRY’ icon on the Info screen do toggle between the harvest
wet yield and weight tally to the dry storage yield and weight tally.
Holding the Moisture Content Reading
If the automatic moisture sensor is producing erratic readings, touch the
content display on the current value. Touch the
38
button to freeze the moisture
icon again to resume a live moisture content display.
SmartYield Installation & Operation Manual