Download Bosch LBB 1925 Operating instructions

Transcript
Plena System Pre-amplifier | Installation and Operating Manual | Internal settings
en | 11
2.5 Setting single and dual channel use
The system pre-amplifier can be used with one booster amplifier for both music and calls ('1 channel use'). Any call
will interrupt background music in all zones. It is also possible to use separate booster amplifiers, for music and calls
('2 channel use'). Now a call will not interrupt music in zones, not addressed by the call. Jumper JP102 selects
whether background music is going to the Master output (1 channel use) or not (2 channel use). Jumper J2 must be
set to either 1 channel use or 2 channel use to select the amplifier terminals for the zones.
2.6 Override contact setting
3-wire (zone 1-6)
D614
RL606
RL605
D613
RL604
RL603
RL602
RL601
100V
CN24
OVERRIDE
CN20
LOCAL VOLUME
CONTROL
CN3
CN21
D606
RL612
D604
RL610
D603
RL609
D602
RL608
D601
RL607
4-wire (zone 1-6)
0V
CN22
D605
RL611
Figure 2.5
100V
24V
RL612
J3
LOCAL VOLUME CONTROL
AMPLIFIER
100V
audio
24V dc
J4
Override
0V
AMPLIFIER
RL611
RL610
RL609
25-6
RL608
OVERRIDE
RL607
3938 101 90272
Figure 2.4
DC Out 24V (-)
Figure 2.6
Jumpers J3 and J4 select whether the override output for each zone (indicated by
) is switching between the 0V
and 100V loudspeaker signal, or between ground and 24Vdc. This override output is available per zone and may be
used to override local volume controls, to make sure that calls are coming through. For 3-wire volume override, the
jumpers should be in 100V audio position. For 4-wire override the jumpers should be in 24Vdc position. The
drawings show the principle of 3- and 4-wire volume override. The override outputs are activated whenever a call is
made, when the emergency input is activated, or an alarm or time signal is triggered. At the same time also the Call
Active relay is activated, providing a potential free contact.
Bosch Security Systems | 2003-09 | 3922 988 99483en