Download Alarm N6 Series Specifications

Operating
It is entered into the circulator as the correction factor RTA
and remains stored there.
i
T-SELECTIRTA-INTERNAL
RTA-INT:
+01.56"C
RTA-NEW:
+02.78"C
The correction factor only refers to this one application. A
26.80"C
altered
new
correction
test setup.
value is required for any new temperature or
a Select T-SELECT and then RTA. Alter the display in
RTA-EXT:
same way as described in chapter 13.4.
t02.89"C
RTA-NEW: +01.87"C
if a value input has been made it can
! Only
switched over to negative (-) values.
26.80"C
be
13.6 Setting temperature limit values
The setting range of the operating temperature of the circulator can be limited if the application or the flash point of the
selected heat transfer liquid requires this.
T-SELECTMIGH-LIMIT
I
H-LIMIT
L-LIMIT:
+154"C
-050°C
LL-NEW:
+3WC
1
1
/
26.90"C
or:
I
H-LIMIT:
L-LIMIT:
t154"C
-027°C
LL-NEU:
-050°C
I
!
This is not a safety element but merely an aid to
help avoid user faults when operating the unit. The
excess temperature protection must be set separately.
When in the external control mode (for EXTERNAL setting
see chapter 13.2),the limits set restrict the temperature in
the circulator's own bath in order to guarantee a higher
degree of safety against unintentional heating up or cooling
down.
a Select T-SELECT and then LIMIT. Alter the display in
same way as described in chapter 13.4.
First HIGH and then LOW-LIMIT.
If the HIGH-LIMIT value is lower than the set temperature value, the set value is decreased according
to the HIGH-LIMIT value.
13.7 Controlling heating and cooling
FUZZY IDENT
43.20"C
Heating and cooling are cycled. !!! is illuminated when
is illuminated when cooling
heating is activated. @ or
is activated. Flashing of the star means a cooling control between 30 and 100%.
lights up if cooling is active with full cooling capacity,
X
lights up if cooling is active with partial cooling capacity,
8
lights up if the cooling unit is off.