Download Dymo Version 7.5 User`s guide
Transcript
MADYMO Coupling Manual Release 7.5 (b) Connections Defining Tied Surfaces If (part of) a MADYMO FE model is to be connected to (part of) an external FE model, add a tied surface. The constraints between the MADYMO surface and the external surface can be defined using TIED_SURFACE.SPOTWELD, TIED_SURFACE.BREAK_FORCE/STRESS. Groups in the coupled FE model should be used for the MASTER_GROUP_LIST. For the SLAVE_GROUP_LIST, groups in other FE_MODEL elements in the MADYMO input file should be used. The nodes of the slave group will be tied to the PARTNER master surface. <TIED_SURFACE.SPOTWELD ID="96" NAME="Spotweld_Cpl" SLAVE_GROUP_LIST="spotweld_gfe" MASTER_GROUP_LIST="Ext_Group_gfe" GAP_TYPE="VALUE" GAP_VALUE="0.1" /> (c) Constraint of MADYMO rigid body and external FE node(s) SUPPORT_RESTRAINT has been added, based on a point-restraint model. In this way external FE nodes can be constrained to MADYMO rigid bodies. In the following example the nodes 101:103 of the external FE model "Coupling/Vehicle_part" are supported on the MADYMO rigid body "/SYS1/Cube_bod". The stiffness and damping characteristics are computed based on the time-step and the damping characteristic according to the critical damping because no user CHARACTERISTIC.LOAD is specified. <SUPPORT_RESTRAINT BODY = "/SYS1/Cube_bod" FE_MODEL = "/Coupling/Vehicle_part" NODE_LIST = "101:103" /> (d) Constraint of MB belt to external FE node POINT_OBJECT.MB being referred from a BELT_SEGMENT now facilitates connecting a belt segment to an external coupled finite element model. Here follows an example which illustrates the usage. <BELT_SEGMENT ID="4" NAME="belt4_Buc_Part" POINT_REF_1="belt2_Buc" POINT_REF_2="belt4_Buc" CHAR="char_132" INITIAL_STRAIN="5.000000E-05" ADD_LENGTH="0.0" /> <POINT_OBJECT.MB ID="3" NAME="belt2_Buc" FE_MODEL="/Coupling_Sys/Ext_Fem" NODE="4" /> <POINT_OBJECT.MB ID="8" NAME="belt4_Buc" FE_MODEL="/Seat_Sys/Shoulder_Belt_Fem" NODE="77" /> 15