Download VHF Wireless Microphone System Operating Instructions
Transcript
TM ® VHF Wireless Microphone System VM-28 Operating Instructions Thank you for purchasing this unit. To make full and effective use of this unit, please read this Owner's Manual carefully before operating it. After reading this manual, retain this booklet together with the Warranty Card for future use in case of maintenance or troubleshooting. Passionate about Music www.BetterMusicBuilder.com VM-28 Receiver Features and Controls (Figure 1) Better Music Builder 8 Channel-A Channel-B Signal Signal 10 12 6 8 16 2 18 0 20 10 12 6 14 4 POWER 14 4 16 2 18 0 20 VM-28 VHF RECEIVER DUAL CHANNEL Channel-A Volume Channel-B Volume Top view 8 Channel-A 10 12 6 Channel-B 4 Signal POWER Signal 8 14 16 2 18 0 10 12 6 14 2 18 4 16 20 0 20 VM-28 VHF RECEIVER DUAL CHANNEL Channel-A Volume Channel-B Volume 1 2 3 4 5 Rear view XLR CHANNEL B OUT XLR CHANNEL A OUT DC 12.5-18.OV TM ANT-B 6 Better Music Builder ® Model: VM-28 CALIFORNIA, UNITED STATES OF AMERICA COMMENTS? E-MAIL: [email protected] www.BetterMusicBuilder.com ENGINEERED AND DESIGN IN U.S.A. RISK OF ELECTRIC SHOCK ON CHANNEL A & B OUT 7 8 1. 2. 3. 4. 5. 6. 7. 8. 9. 9 POWER 10 11 ANT-A OFF 12 Channel-A Power. AF Peak indicators (Channel-A). AF Peak indicators (Channel-B). Channel-A AF volume adjust output jacks +/-15KHz. Channel-B AF volume adjust output jacks +/-15KHz. Reveicer Antenas-B. Channel-B XLR balance audio output 50Hz~15KHz +/-3dB. Channel-A XLR balance audio output 50Hz~15KHz +/-3dB. Mixed channels (A & B) 1/4-inch unbalance audio output connector. 10. Docking power supply with removable IEC cable 12.5-18.0 V. 11. Power switch On/Off. 12. Reveicer Antenas-A. 2 13 MUTE ON LOW BAT OFF PWR VM-28 Handheld Transmitter (Figure 2) 9V ALKALINE BATTERY Better Music Builder TRANSMITTER FREQUENCY: 14 15 16 17 13. 14. 15. 16. 17. Rugged unidirectional dynamic element. Easily-accessible power switch On/Off. Indicates low battery Transmitter On and Mute switch. Variable battery cover. ON MUTE LOW BAT OFF PWR VM-28 Transmitter Features and Controls (Figure 3) OFF PWR LOW BAT ON Battery condition Indicator: After battery is installed, turn the power on. The battery condition indicator signal light should flash once. If it does not, the battery is installed incorrectly or it is dead. If the indicator signal light stays on (does not flash), the battery voltage is low and the battery should be replaced. If this happens during use, replace (or recharge) the battery immediately to ensure continued operation. Transmitter power switch (On/Off) MUTE 3 Handheld Transmitter Channel A (Figure 4) 9V ALKALINE BATTERY MUTE ON LOW BAT OFF PWR 9V ALKALINE BATTERY Better Music Builder TRANSMITTER FREQUENCY: Make sure that you insert the battery at the right electric poles. Handheld Transmitter Channel B (Figure 5) MUTE ON LOW BAT OFF PWR 9V ALKALINE BATTERY 9V ALKALINE BATTERY Make sure that you insert the battery at the right electric poles. 4 Better Music Builder TRANSMITTER FREQUENCY: ON MUTE OFF PWR Channel A Handheld Transmitter LOW BAT ON MUTE OFF PWR LOW BAT VM-28 VHF Wireless System Chart (Figure 6) Channel B Handheld Transmitter XLR CHANNEL B OUT XLR CHANNEL A OUT DC 12.5-18.OV TM ANT-B Better Music Builder ® Model: VM-28 CALIFORNIA, UNITED STATES OF AMERICA COMMENTS? E-MAIL: [email protected] www.BetterMusicBuilder.com ENGINEERED AND DESIGN IN U.S.A. RISK OF ELECTRIC SHOCK ON POWER CHANNEL A & B OUT ANT-A OFF Rear View Balance Connection XLR XLR XLR XLR 1/4" 1/4" 1/4" 1/4" Balance Input Balance Input Balance Input Balance Input Unbalance Input Unbalance Input Unbalance Input Unbalance Input Audio Mixer Amplifier or a Karaoke Unit Input terminal 120V AC Adaptor Audio Cable Balance (Figure 7) Audio Cable Unbalance (Figure 8) 2 SHIELD SLEEVE HOT SLEEVE TIP TIP COLD SHIELD 3 1 RING (COLD) 1 TIP (HOT) SLEEVE (SHIELD) COLD 3 HOT 1 3 UNBALANCE XLR CONNECTORS 2 SHID COLD 2 HOT BALANCE XLR CONNECTORS 5 ON Channel B Handheld Transmitter XLR CHANNEL B OUT XLR CHANNEL A OUT DC 12.5-18.OV TM ANT-B MUTE OFF PWR Channel A Handheld Transmitter LOW BAT ON MUTE OFF PWR LOW BAT VM-28 Basic Karaoke Connection Diagram (Figure 9) Better Music Builder ® Model: VM-28 CALIFORNIA, UNITED STATES OF AMERICA COMMENTS? E-MAIL: [email protected] www.BetterMusicBuilder.com ENGINEERED AND DESIGN IN U.S.A. RISK OF ELECTRIC SHOCK ON CHANNEL A & B OUT POWER ANT-A OFF Rear View Unbalance Connection MIC 1 MIC 2 DVD Karaoke Player DVD Audio connect to Amplifier Video connect to TV/Video Monitor Specifications RF Carrier Frequency Range: 169.445 to 221.350 MHz Working Range: 100 ft under typical conditions. Audio Frequency Response: 50 to 15,000 Hz, +/-2 dB Audio Output Level (+/-15 kHz deviation, 1 kHz tone) 1/4~inch connector (into 3 k Ohm load): -8.8 dBV (Hi Z) 1/4~inch connector (into 3 k Ohm load): -18 dBV (mix) RF Power Output: about 30 mWatt Battery Size: 9V rechargeable Receiver Dimensions: 220mm(W)x40mm(H)x130mm(D) Handheld Transmitter Dimensions: 240mm(L)x55mm(H)x30mm(W) Net Weight: 2 lbs 6 Warranty WARRANTY One-Year Limited Warranty for Home Use Equipment Our one-year warranty applies to speakers, amplifiers, mixers and microphones for home use only. It covers both parts and labors. The warranty becomes effective from the date of your purchase for one year. Our warranty only covers defects due to product defectiveness with free of defects in materials or workmanship. However, our warranty does not cover defects due to normal wears, damage in transit, improper use, abuse or failure to follow the proper instructions for maintenance. This warranty is void in the event of unauthorized repairs, alternations, modifications and removing of the product label. Please also note that our warranty does not cover any shipping cost for the return of defective products to us for inspection, repair and maintenance. Our warranty for Better Music Builder products can only be executed in North America. NOTE Our warranty does not cover the battery for wireless microphone products. 90-Day Limited Warranty for Public and Commercial Use Equipment Our 90-day warranty applies to speakers, amplifiers, mixers and microphones for both public and commercial use such as restaurant, coffee shop, KTV nightclub, church and school, etc. It covers both parts and labors. The warranty becomes effective from the date of your purchase for 90 days. To Register Your Warranty Please fill out the warranty card that came with your unit, download or submit online warranty form. However, we need the invoice for your purchase in order to process this warranty. You may also register your warranty online. Please visit our website at www.bettermusicbuilder.com. Precaution 1. If you want to use more than one of this system, please select the work frequency (or signal channel) carefully so as to avoid disturbing. 2. The input power voltage of the receiver is 120V (±10%). If it is too low or too high, it will affect the work of the machine. 3. When you install the battery, you must not reverse the electrode or you will damage the machine. 4. When using the sensitivity solution function, the numerical value you select must be at least 15dB. Otherwise, if the distance is too far, its signal-to noise radio goes worse. This symbol, wherever it appears, alerts you to the presence of uninsulated dangerous voltage inside the enclosure voltage that may be sufficient to constitute a risk of shock. RISK OF ELECTRIC SHOCK DO NOT OPEN Caution: To reduce the risk of electrical shock, do not remove the cover (or back). No user serviceable parts inside: refer servicing to qualified personnel. This symbol, wherever it appears, alerts you to important operating and maintenance instructions in the accompanying literature. Read the manual. Warning: To reduce the risk of fire or electrical shock, do not expose this appliance to rain or moisture. 7 TM ® Passionate about Music www.BetterMusicBuilder.com Printed on 100% Recycled Paper ©2007 Better Music Builder (USA) Comments E-mail to [email protected] All Rights Reserved in USA.