Download RAID_Firmware_Users_..

TABLE 14-4
Parameters
Description
SID
Secondary controller’s ID mapping:
DefSynClk
DefWid
S
Term
CurSynClk
292
Parameters Displayed in the Channel Status Table (Continued)
*
Multiple IDs (host channel mode only).
#
The ID to which host LUNs are mapped in the host channel
mode. The ID for the secondary controller in drive channel
the mode.
NA
No ID applied.
Default bus synchronous clock:
xx.x MHz
Maximum synchronous transfer rate (SCSI array only)
x GHz
Maximum synchronous transfer rate (FC array only).
Async
Channel is set for asynchronous transfers (SCSI arrays
only).
Auto
Channel is configured to communicate at 1 or 2 GHz (FC
arrays only).
Default bus width:
Wide
Channel is set to allow wide (16-bit) transfers (SCSI arrays
only).
Narrow
Channel is set to allow narrow (8-bit) transfers (SCSI arrays
only).
Serial
Channel is using serial communication.
Signal:
S
Single-ended
L
LVD
F
Fibre
Terminator status:
On
Termination is enabled (SCSI arrays only).
Off
Termination is disabled (SCSI arrays only).
NA
For a redundant controller communications (RCCOM)
channel (SCSI arrays) and all FC array channels.
Current bus synchronous clock. This field only displays values for channels
that are assigned to the primary controller.
xx.x MHz
The current speed at which a SCSI array channel is
communicating.
x GHz
The current speed at which a FC array channel is
communicating.
Sun StorEdge 3000 Family RAID Firmware 4.15 User’s Guide • May 2006