1
Download HP SN6000 Command Reference Guide
Transcript
portThConfig 2 LR Link reset TU Trunk Utilization Only the following areas are valid for VE_Ports. UTIL Port utilization PKTLOSS Packet loss ST State change SL Loss of signal --set Configures the Fabric Watch thresholds for monitoring a specified area for all ports of a specified port type. When configuring a threshold, you must specify a port type and area. The following operands are optional and valid only with the --set option. Defaults are used unless you configure custom settings. Defaults parameters vary depending on the area and platform. Refer to the Fabric Watch Administrator's Guide for specific details. -timebase time_base Specifies the time interval between two samples to be compared. Valid intervals include the following: day Samples are compared once a day. hour Samples are compared once every hour. minute Samples are compared once every minute. -highthreshold -value value Specifies the high threshold value for triggering a specified alert action. To change the default value, provide an integer value. -lowthreshold -value value Specifies the low threshold for triggering a specified alert action. To change the default value, provide an integer value. -trigger above | below Specifies the actions for in range port behavior. In range is defined as the space above the low threshold and below the high threshold. -action actions Specifies the actions triggered by a configured event condition. Valid values include one or more of the following actions. If more than one action is specified, the actions must be separated by commas.To change the existing configuration of actions, you must first issue the command with the none option to reset the existing configuration, and then reissue the command with the new configuration of actions. raslog Event triggers a RASlog message. snmp Event triggers an SNMP trap. Fabric OS Command Reference 53-1003108-01 925
