1
Download HP SN6000 Command Reference Guide
Transcript
portCfg 2 modify [circuit_ID] [circuit_arguments Modifies the properties of an existing FCIP circuit. To modify a circuit, you must specify at least one of the optional circuit parameters for the command to be effective. Any circuit attribute you change with the fcipcircuit modify command affects only the specified FCIP circuit. All other circuits remain unchanged. Refer to fciptunnel create and modify for a listing of optional circuit arguments and their descriptions. delete circuit_ID Deletes the specified FCIP circuit. mgmtif Configures an inband management interface. A maximum of one interface is supported per GbE Port. Up to a total of 6 management interfaces are supported for the Brocade 7800 and up to a total of 11 interfaces for the Brocade FX8-24 (depending on blade operating mode). The interfaces must each exist on a unique network, separate from the other inband management interfaces and from all other interfaces on the CP. The syntax for mgmtif is as follows: mgmtif ge_port [options] arguments Valid options and arguments for mgmtif include the following: create Creates a specified IP Address for the inband management interface. The IP address must be unique. IPv4_address Specifies an IP address for the inband management interface in IPv4 format, followed by the subnet mask. netmask Specifies the subnet mask for the IPv4 address in a.b.c.d format. MTU Specifies the MTU for the inband management interface. The valid range is 1260 to 1500. This operand is optional. delete Deletes the specified IP Address for the inband management interface. IPv4_address Specifies the IP address to be deleted. disable Disables the inband management interface at the specified GbE Port. enable Re-enables the inband management interface at the specified GbE Port after it has been disabled. The interface is by default enabled when it is created. mgmtroute Configures the management route for the inband management interface (needed only if the management interfaces are on different subnets). The syntax for mgmtroute is as follows: mgmtroute ge_port [options] destination_ip_address Fabric OS Command Reference 53-1003108-01 701
