Download User Manual - Projector Central

4. Controlling the projector
Digital Projection TITAN
Geometry menu
Notes
To return to the main menu, press
up to three times.
From the main menu:
•
Press
and
until Geometry is highlighted.
to open the Geometry menu. The blue highlight moves to the first item
Press
in the menu.
Input
Picture
Geometry
Colour
Setup
Information
H Position
V Position
Aspect Ratio
User H Aspect
User V Aspect
Keystone
Phase
Resolution
Blanking
Press
and
to select H Position.
Press
and
to adjust the slider.
Some menu controls can be
accessed directly using the
control keys (see earlier in this
section).
When using the menus, press
or
to hide or
OSD
reveal the On-Screen-Display.
128
64
1.85:1 (Flat)
500
500
0
127
Horizontal Position
•
HD-600 User Manual
Geometry Menu
Some menu items may be
greyed out - unavailable due to
the effect of settings made in
other menus, or due to the type
of input signal.
Vertical Position
•
Press
and
to select V Position.
Press
and
to adjust the slider.
Aspect Ratio
•
Press
and
Fill
to select from:
This will best fit the incoming source to fill either the height or
width without changing the aspect ratio of the source.
User Aspect
1.33:1 (4:3)
Aspect Ratio selection can be
found in both the Picture and
Geometry menus.
When User Aspect is selected,
the Aspect Ratio settings are
taken from the User H Aspect
and V Aspect settings (see
next page).
1.78:1 (16:9)
2.35:1 (Scope)
1.66:1 (Vista)
1.85 (Flat)
Theaterscope
Use with the TheaterScope Anamorphic System only. The
2.35:1 source image is displayed using the full area of the 16:9
DMD. This is then stretched to 2.35:1 by the lens.
Native
The image will be displayed pixel for pixel. The image will be
centred, with a black border if smaller than native resolution or
cropped if larger.
Page 4.24
Rev A. March 2008