Download MVME5100 Single Board Computer Programmer`s Reference

MVME5100 VPD Reference Information
A.1.1

VPD Definitions - FLASH Memory Configuration Data on page 301

VPD Definitions - L2 Cache Configuration Data on page 302

VPD Definitions - VPD Revision Data on page 304
How to Read the VPD Information
There are several ways to read VPD information:
A.1.2

Version command - ver
Displays most of the identification strings and hardware clock frequencies

Serial EEPROM command - srom;i
Can be used as a byte viewer

Indirect block move command - ibm<addr>;i
Reads the entire SROM block to memory

Memory display command - md<addr>
Can be used to display a VPD block which has been copied to memory

Network I/O physical command - niop
Can be used to upload a VPD block from memory to a network file
How to Modify the VPD Information
The following commands can be used to modify the VPD information in various ways:
294

Serial EEPROM command - srom;i
Can be used as a byte editor

Network I/O physical command - niop
Can be used to download a VPD block from a network file to memory

Indirect block move command - ibm<addr>;iw
Writes a block of memory into the SROM
MVME5100 Single Board Computer Programmer’s Reference (6806800H17B)