Download the dynamic estuary model hydrodynamics program, dynhyd5 model

Transcript
"typical" Manning Roughness coefficients. The value of this
coefficient should usually lie between 0.01 and 0.08. Because
this parameter cannot be measured, it serves as a "knob" for the
calibration of the model.
Velocity, m/sec--An initial estimate of the mean channel
velocity is required. Although any value may be assigned, the
computational time required for convergence to an accurate
solution will depend on how close the initial estimate is to the
true value. Convergence is usually rather quick.
Hydraulic radius, m--Previous applications of DYNHYD have
used channels whose widths are greater than ten times the channel
depth. Consequently, the hydraulic radius is usually assumed to
be equal to the mean channel depth.
Channel orientation, degrees--The channel orientation is the
direction of the channel axis measured from true north. The axis
is assumed to point from lower junction number to higher junction
number, which by convention, is the direction of positive flow
(i.e.: upstream to downstream).
1.5.3 Inflow/Outflow Parameters
25