Download the dynamic estuary model hydrodynamics program, dynhyd5 model
Transcript
"typical" Manning Roughness coefficients. The value of this coefficient should usually lie between 0.01 and 0.08. Because this parameter cannot be measured, it serves as a "knob" for the calibration of the model. Velocity, m/sec--An initial estimate of the mean channel velocity is required. Although any value may be assigned, the computational time required for convergence to an accurate solution will depend on how close the initial estimate is to the true value. Convergence is usually rather quick. Hydraulic radius, m--Previous applications of DYNHYD have used channels whose widths are greater than ten times the channel depth. Consequently, the hydraulic radius is usually assumed to be equal to the mean channel depth. Channel orientation, degrees--The channel orientation is the direction of the channel axis measured from true north. The axis is assumed to point from lower junction number to higher junction number, which by convention, is the direction of positive flow (i.e.: upstream to downstream). 1.5.3 Inflow/Outflow Parameters 25