1
Download User Manual - Pid Controller
Transcript
33 Alarm 2 Reset Type of Reset for contact of alarm 2 (Automatic Reset) Default (Manual Reset) (Manual Reset Stored) 34 State of contact for alarm Alarm 2 State 2 output in case of error Default Error 35 Alarm 2 Led 36 State of OUT2 led corresponding to relative contact Alarm 2 hysteresis Alarm 2 Hysteresis Alarm 2 delay 37 Alarm 2 Delay 38 Alarm 2 Setpoint Protection 39 Alarm 3 Alarm 2 set protection. Does not allow operator to change value of setpoint Alarm 3 selection. Alarm intervention is associated with AL3 Default -999…+999 digit∗ (tenths of degree if temperature). Default: 0. -180…+180 Seconds Negative: delay in alarm output phase. Positive: delay in alarm entry phase. Default: 0. Default (Disabled) Default (Absolute Alarm) (Band Alarm) (High Deviation Alarm) (Low Deviation Alarm) (Absolute Command setpoint Alarm) (Start Alarm) (Cooling) ∗ The display of the decimal point depends on the setting of parameter and parameter . 37
