Download WaveGuide - Water Level User Manual

Chapter 3
WaveGuide system commissioning
With all the wiring in place as described in the previous chapter, the server can be configured
using the following steps (explained in the current chapter):
1. Connect the WaveGuide server to a computer.
2. Become an authorized user.
3. Enable expert mode.
4. Set radar sensor parameters
5. Perform a system check.
6. Set system date/time.
7. Configure the distribution of data.
The display on the server shows system information and measured parameters and is controlled using,
• Button 1: To switch between groups.
• Button 2: To switch between items within each group.
• Button 5: To confirm mounting and unmounting of USB data storage.
The server display contains the following groups and items:
• Parameters
– Scrolls through selected parameters (Appendix 1, Table 1)
• Network
– Host name
– IP address
• System information
– Date and time
– Uptime
– Software version
• USB storage (only appears when USB device is connected)
– State
– Mount USB disk?/ Unmount USB disk?
9