Download 78K0 Debug - Renesas Electronics

CubeSuite+ Ver.1.00.00
APPENDIX A WINDOW REFERENCE
(b) Event mark
The event mark shows the type of event, and in addition shows the current setting state.
The meanings of the marks displayed are as follows:
Table A-10. Event Mark
Event Type
Valid State
Invalid State
Suspended
Note
State
Hardware Break
-
Software Break
-
(except [Simulator])
Unconditional Trace
None
-
None
-
[IECUBE][Simulator]
Run-Break Timer
None
Trace
Used only in the Events panel
[IECUBE][Simulator]
Used only in the Editor panel/
Start Tracing
Disassemble panel
Stop Tracing
Timer Result
Used only in the Events panel
[IECUBE][Simulator]
Used only in the Editor panel/
Start Timer
Disassemble panel
Stop Timer
Point Trace
-
[IECUBE][Simulator]
Printf (Action event)
Setting of two or more
Note 1
Note 2
events
Notes 1.
Note 3
Used only in the Editor panel/
Disassemble panel
There is one or more event with valid state.
2.
There is no event with valid state and at least one event with invalid state.
3.
All the set events are suspended state
R20UT0559EJ0100 Rev.1.00
Apr 01, 2011
Page 261 of 493