Download PACSystems Memory Xchange Modules Users` Manual

Transcript
3
RMX128 LEDs
LED Label
OK
LINK OK
Description
OK
ON indicates the module is
functioning properly.
LINK OK
SIG DETECT
OWN DATA
When used as a redundancy link,
ON indicates the link is
functioning properly. When not
used as a redundancy link, ON
indicates the module is
configured.
SIG DETECT
ON indicates the receiver is
detecting a fiber optic signal.
OWN DATA
ON indicates the module has
received its own data packet from
the network at least once.
LOCAL
READY
ON indicates the local unit
is ready.
LOCAL
ACTIVE
ON indicates the local unit
is active.
REMOTE
READY
ON indicates the remote unit
is ready.
REMOTE
ACTIVE
ON indicates the remote unit
is active.
RMX128
1
ROLE
SWITCH
0
LOCAL
READY
ACTIVE
REMOTE
Optical
Transceiver
(bottom view)
TX
READY
ACTIVE
NODE
TX (FRONT)
RX (BACK)
RX
Optical Transceiver
The optical transceiver, which is located on the bottom of the module, has two
“LC” type fiber optic ports. The port labeled “TX” is the transmitter and the port
labeled “RX” is the receiver.
CMX modules are networked together using either simplex (single fiber) or duplex
(dual fiber) multimode fiber optic cables. The specific cable construction depends
on your operating environment. For details on cables, see “Fiber Optic Cables and
Connectors” on page 3-10.
GFK-2300D
Chapter 3 Installation and Configuration
3-3