Download Data Acquisition Toolbox User`s Guide
Transcript
Configuring Analog Input Triggers The data acquired for both triggers is shown below. daqdoc3_6 Voice Activation First Trigger Signal level (Volts) 0.6 0.4 0.2 0 −0.2 −0.4 −0.6 −0.8 0 0.1 0.2 0.3 0.4 0.5 Time (sec.) Voice Activation Second Trigger Signal level (Volts) 0.6 0.4 0.2 0 −0.2 −0.4 −0.6 −0.8 0.5 0.6 0.7 0.8 Time (sec.) 0.9 1 As described in “Extracting Data from the Engine” on page 5-13, if you do not specify the amount of data to extract from the engine with getdata, then the amount of data returned is given by the SamplesPerTrigger property. You can return data from multiple triggers with one call to getdata by specifying the appropriate number of samples. When you return data that spans multiple triggers, a NaN is inserted in the data stream between trigger events. Therefore, an extra “sample” (the NaN) is stored in the engine and returned by getdata. Identifying these NaNs allows you to locate where and when each trigger was issued in the data stream. 5-33
Related documents
"user manual"
Data Acquisition Toolbox 2 User`s Guide
Data Acquisition Toolbox Reference
Wellav DMP900 Digital Media Platform User Manual
1 Video Eyetracker Toolbox
Image Acquisition Toolbox
Using the DAQ Adaptor for MATLAB
Tema: Señales y Sistemas Discretos en el tiempo
Data Acquisition Toolbox User's Guide
MATLAB IMAGE ACQUISITION TOOLBOX 3 User`s guide
Syncdrive Plus Communications Software User`s Manual CONNECT
PC-Sonar User Guide