Download ⅠForeword - Happylab

COLE Laser Engraving Machine Manual
6.8 Hole
6.7.1 PWM Frequency
It determines the frequency of PWM signal.
Ⅶ Method to Create Vector Figure File (PLT DXF)
This software support the vector files including : PLT, DXF (R12 )
Vector file can be created by the software such as AutoCAD, CorelDraw ,
Wentai ，etc.
一、Create DXF file in AutoCAD
Current AutoCAD software function is very strong and convenient.
Run the program, draw and layout according to size proportion (1:1 proportion);
the whole figure must be smaller than 650X450mm2, and the coordinate zero
point should be set in the left-bottom corner. Output the file into DXF format
through AutoCAD R12 Version
The methods and skills of using AutoCAD , please consult to AutoCAD service
manual or relative books.
二、Create PLT file in CorelDraw
Run CorelDraw software;
Layout and set the size in CorelDraw;
Choose "file - output" in the menu;
Choose PLT format in “ file type " of the output the communication frame;
Click the output button.
The methods and skills of using CorelDraw , please consult to CorelDraw
service manual or relative books.
三、Create figure file in Wentai software.
Run Wentai painting / engraving software ;
53