Download INSTRUCTION MANUAL

PROPELLER MOUNTING
The collet shaft included with your Rifle spinner is designed
to work with the small O.D. propeller spacer ring that comes
with all APC speed 400 propellers.
Enlarge as
necessary
❏ A. To prep the prop, press the spacer all the way into
the propeller hub. Then use a #11 blade to carefully trim
any flashing from around the inside of the spacer.
❏ 5. The
front bearing on some motors protrudes slightly
from the front of the motor. If this is the case for your motor,
use a Dremel with a tile cutter bit and/or a small drum sander
to enlarge the hole as necessary. Proceed slowly and with
care to keep the hole centered and so as not to over enlarge
the hole—this may require test-fitting the motor as you
proceed. CAUTION: Wear protective gloves, a long-sleeve
shirt and breathing and eye protection whenever working
with carbon fiber.
❏ B. Firmly press the propeller onto the collet shaft.
❏ 6.
Test-mount the motor with your motor mounting
screws—if using the recommended Ammo motor you may
use the M3 x 5 screws included with the motor, but some
prefer button-head Allen screws instead (such as the screws
shown in the photo—HPIC3250).
❏ C. An 8mm wrench is a must for your tool box. A Traxxas
8mm flat wrench is pictured here (TRAR5478).
6