Download LabWindows/CVI PID Control Toolkit Reference Manual
Transcript
Chapter 1 PID Control Toolkit Overview This example uses an integrating process with added noise, valve dead band, lag, and dead time. This simple example does not account for time; thus, it does not correct itself for loop cycle time. This example also demonstrates switching from automatic to manual mode. PIDDAQ PIDDAQ is a real controller for a resistor-capacitor network. It requires a National Instruments I/O board and the resistor-capacitor network detailed on the user interface panel. It uses a single conventional PID loop to control the output voltage of the resistor-capacitor network. The PID tuning parameters are available on the panel for modification at run time. Figure 1-4. Front Panel of the Resistor-Capacitor Network Example LDLGDEMO LDLGDEMO demonstrates the Lead-Lag functions. It requires no plug-in boards or external hardware. Input for the Lead-Lag function is either a sine wave or a square wave. The waveform is synchronized to the Cycle Time chosen. Varying the tuning parameters demonstrates the time-domain response of the Lead-Lag functions. Notice that a large Lead © National Instruments Corporation 1-13 LabWindows/CVI PID Control Toolkit