Download User Manual

Transcript
CHAPTER 5: CONFIGURATION MENU
Liquid Class parameters include density, aspirate speeds, dispense speeds,
post-aspiration delays, post-dispense delays, blow out delays and number of
pre-wet cycles as described below.
Density
Defines the mass of the fluid per unit volume. Density is measured in g/mL.
Number of Replicates
Defines the number of times a particular volume will be pipetted and weighed
during gravimetric calibration. The software will calculate the average mass from
these replicates and use this average mass value and the density to adjust the
data points of a Liquid Class curve.
Pre-Blowout Delay
Defines the amount of time the system waits after dispensing fluid and before
dispensing the blowout.
Post-Blowout Delay
Defines the amount of time the system waits after dispensing the blowout and
before re-aspirating the blowout volume in preparation for the next pipetting activity.
Aspirate Speed
Defines how quickly the fluid is aspirated. Slower speeds may be used for
viscous and/or volatile fluids to prevent cavitation and/or boiling. Speed
options include:
Fast: 7.5 µL/sec for volumes ≤15 µL, 300 µL/sec for volumes >15 µL
Recommended: 5 µL/sec for volumes ≤15 µL, 200 µL/sec for volumes >15 µL
Slow: 2.5 µL/sec for volumes ≤15 µL, 100 µL/sec for volumes >15 µL
Post-Aspirate Delay
Defines the amount of time the system waits after an aspiration to allow the
system to reach mechanical and pressure equilibrium. The operator is
expected to maintain the tip within the fluid during this time interval. Longer
delays may be needed to adjust for faster aspirate speeds and/or more
viscous fluids.
46