Download User`s Manual

SIP User's Manual
6.15
6. Configuration Parameters Reference
Hunt Groups, Number Manipulation and Routing
Parameters
This subsection describes the device's number manipulation and routing parameters.
6.15.1 Hunt Groups and Routing Parameters
The routing parameters are described in the table below.
Table 6-54: Routing Parameters
Parameter
Description
Web: Endpoint Phone Number Table
EMS: SIP Endpoints > Phones
[TrunkGroup]
This ini file table parameter is used to define and activate the
device's endpoints, by defining telephone numbers and
assigning them to Hunt Groups. The format of this parameter is
shown below:
[TrunkGroup]
FORMAT TrunkGroup_Index = TrunkGroup_TrunkGroupNum,
TrunkGroup_FirstTrunkId, TrunkGroup_FirstBChannel,
TrunkGroup_LastBChannel, TrunkGroup_FirstPhoneNumber,
TrunkGroup_ProfileId, TrunkGroup_LastTrunkId,
TrunkGroup_Module;
[\TrunkGroup]
For example, the configuration below assigns channels 1
through 4 to Hunt Group 1 and assigns phone numbers 101 to
Channel 1, 102 to Channel 2, and so on:
TrunkGroup 0 = 1, 255, 1, 4, 101, 0, 255, 255;
Notes:
Version 6.0
ƒ
The first entry in this table starts at index 0.
ƒ
Each endpoint (i.e., channel) must be assigned a unique
phone number. In other words, no two endpoints can have
the same phone number.
ƒ
The parameters TrunkGroup_FirstTrunkId,
TrunkGroup_LastTrunkId, and TrunkGroup_Module are not
applicable.
ƒ
For configuring this table in the Web interface, refer to
“Configuring Endpoint Phone Numbers” on page 143 .
ƒ
For a description of ini file table parameters, refer to
''Configuring ini File Table Parameters'' on page 186.
331
March 2010