Download User`s Manual

Transcript
SIP User's Manual
3.3.3.7
3. Web-Based Management
Configuring the IP Security Proposal Table
The 'IP Security Proposals Table' page is used to configure Internet Key Exchange (IKE)
with up to four proposal settings. Each proposal defines an encryption algorithm, an
authentication algorithm, and a Diffie-Hellman group identifier. The same set of proposals
apply to both Main mode and Quick mode.
Note: You can also configure the IP Security Proposals table using the ini file table
parameter IPsecProposalTable (refer to ''Security Parameters'' on page 232).
¾ To configure IP Security Proposals:
1.
Open the ‘IP Security Proposals Table’ page (Configuration tab > Security Settings
menu > IPSec Proposal Table).
Figure 3-54: IP Security Proposals Table
In the figure above, two proposals are defined:
•
Proposal 0: AES, SHA1, DH group 2
•
Proposal 1: 3DES, SHA1, DH group 2
Note that with this configuration, neither DES nor MD5 can be negotiated
2.
Select an Index, click Edit, and then modify the proposal as required.
3.
Click Apply.
4.
To save the changes to flash memory, refer to ''Saving Configuration'' on page 161.
To delete a proposal, select the relevant Index number, and then click Delete.
Table 3-10: IP Security Proposals Table Configuration Parameters
Parameter Name
Description
Encryption Algorithm
[IPsecProposalTable_EncryptionAlgorithm]
Determines the encryption (privacy) algorithm.
Authentication Algorithm
[IPsecProposalTable_AuthenticationAlgorithm]
Version 6.0
79
ƒ
[0] NONE
ƒ
[1] DES CBC
ƒ
[2] 3DES CBC
ƒ
[3] AES (default)
Determines the message authentication
(integrity) algorithm.
ƒ
[0] NONE
ƒ
[2] HMAC SHA1 96
ƒ
[4] HMAC MD5 96 (default)
March 2010