Download SB-10 USER`S MANUAL

Overprinting
The “Overprinting”
category will want to know how your printer
backspaces.
Press C and, from a list of three choices, choose
“backspacing
standard printer”; then press Y or <return > to
confirm your choice.
Next you will be prompted to enter the “backspacing
code sequence.” Press C, then type in “8h”, and finish by pressing the return
key.
Boldfacing
Your next category, “Boldfacing”,
informs you directly of the
correct number of strikes for boldface printing: 2. So, press C, 2,
and <return >.
Communications
protocol
If you are using the parallel interface, no protocol is necessary for
this printer. (For the code sequences used in the various serial interface protocols, please see Appendix H.)
Printer driver
If you have chosen “Primary list device” as your printer driver, then
the correct codes for that device will already be entered in this category, and no further input is necessary on your part. Press < return > to exit this category.
Ribbon selection
This category also does not apply to your printer, so please press
< return > to exit.
Vertical motion and Horizontal
motion
When you chose “Automatic Installation for Specialty Printers,”
the installation program automatically entered the necessary codes
for these two categories. No further input is necessary, so just press
<return > to pass through them unchanged.
Print modes
This category asks for the code sequences of the backward and
forward print modes, You should also pass through these sequences
unchanged.
Print phantom
characters
This category does not apply to your printer , so press <return >
to pass through it. You will be returned to the Printer Installation
Menu, and may now enter the special features of the printer that
you’ll want to use on a regular basis: emphasized, expanded, and
underlined printing, or any of the other features you’ve iearned about
in this book.
97