Download English - Magtrol

Chapter 8 – Adjust PID
8.2
Magtrol EM-TEST2.0 Motor Testing Software
Adjusting the Controller for aN endurance Test
Note:
When amps, input watts, output watts or output kW endurance tests
are being performed, only the proportional gain (P) can be adjusted.
Set P to 35.
Set I and D to 0.
Set PS, IS and DS to 0,001 (A).
Set High Value to the highest load used on the motor during testing.
Set Low Value to the lowest load used on the motor during testing.
Set Dwell to 2 or 3 seconds.
Set Motor Voltage to appropriate value if a motor power supply was selected in the Configure
Hardware window.
8.Click Run. The result will appear similar to the following example.
1.
2.
3.
4.
5.
6.
7.
44
TEST SETUP
Figure 8–2 Curve (no I or D)