Download E-GATE user manual

Appendix A: scale head factory defaults
The air regulator is an auto-drain water separator. Because of the harsh environment
in hog barns, carefully monitor the regulator to make sure it drains properly.
Each week, inspect all load arms and load arm hanging brackets for cracked or broken
welds.
Cleaning the scale head
Keep the cover of the scale head clean. To clean the cover, wipe it with a cloth and mild
detergent or water.
‘
Use only a soft cloth and mild detergent to clean the cover. Do not use harsh
chemicals or abrasive cleaners—they can scratch the surface.
‘
Be careful when washing the room using a high-pressure washer. DO NOT spray
the control using a high-pressure washer, especially around the hose and
cable connections. Evidence of moisture damage inside the control will void
the warranty.
Appendices
„
Appendix A: scale head factory defaults (below)
„
Appendix B: Troubleshooting (on page 87)
„
Appendix C: Hints, tips, and questions (on page 91)
„
Appendix D: Calibrating the scale (on page 92)
Appendix A: scale head factory defaults
The table below lists the factory defaults for the E-GATE scale head. For more
information, read Loading factory defaults on page 82.
84
2008-09-03