Download AMC121

Document Revision History
Date
Explanation of changes
July 07, 2008
Initial Production Release
October 21, 2008
Updated Table 4-1, “IPMI/PICMG Command Subset Supported by the MMC
Firmware,” on page 48. Updated upper CPU temperature thresholds in Table , “Table
4-4 lists the sensors that are monitored by the MMC. Note that the sensor IDs are
local to the MMC. The MMC’s SDRs are inherited by the next level of management
(µTCA MCMC or AMC carrier IPMC) and sensor IDs are reassigned.,” on page 52.
Updated Web links.
March 19, 2009
Added caution and warning about product handling in “Safety” on page 88.
June 10, 2009
Standardized “Module Management Controller” on page 24, “Serial I/O” on page 25,
and Chapter Chapter 4, “System Monitoring and Alarms.”. Updated “Memory
Configuration” on page 36, “DDR SDRAM Connector” on page 76, and “Battery
Backup Characteristics” on page 82 to indicate that memory and batteries are not field
servicable items. Removed “Balcony Board Switch” topic. Added caution to “Balcony
Board” on page 31 and “Balcony Interface Connector” on page 76 and added notes to
Figure 5-1, “Connector Locations,” on page 71 and Figure 5-3, “Connector Locations
(Balcony),” on page 77. Changed name of SW2 to Multifunction Swich and clarified
“SW2-3 (Position 3) - Spread Spectrum Clock (SSC)” on page 40. Expanded “USB
CD/DVD” on page 44. Corrected board height specification on page 83.
October 2, 2009
Standardized Chapter Chapter 9, “Agency Approvals” on page 87.
December 1, 2009
Updated “SW2-2 (Position 2) - FCLKA Configuration” on page 40 to reflect new default
setting. Corrected note in “SW2-4 (Position 4) - MMC Serial Access / Serial Port” on
page 41. Corrected “MMC Sensors” on page 52. Added topic “Power On Reset” on
page 79.
February 2, 2011
Rebranded and reformatted entire document. Updated “Payload Shutdown Timeout”
on page 60.
Copyright Notice
© Copyright 2008-2011 Performance Technologies, Inc. All Rights Reserved.
The Performance Technologies logo is a registered trademark of Performance Technologies, Inc.
All product and brand names may be trademarks or registered trademarks of their respective owners.
This document is the sole property of Performance Technologies, Inc.
Errors and Omissions
Although diligent efforts are made to supply accurate technical information to the user, occasionally
errors and omissions occur in manuals of this type. Refer to the Performance Technologies, Inc. Web
site to obtain manual revisions or current customer information:
http://www.pt.com.
Performance Technologies, Inc., reserves its right to change product specifications without notice.
2