Download 4 - SEW-Eurodrive
Transcript
Description of the Function Modules Directory MDX_InverterParameters Outputs 4 The function module MC_SetJerk_MDX has the following outputs: Output Type Description Done BOOL This output shows whether the jerk time has been transferred. • TRUE: The jerk time has been transferred from the MOVI-PLC® controller to the drive inverter. • FALSE: The jerk time has not been transferred. Busy BOOL This output shows whether the jerk time is being transferred. • TRUE: The jerk time is being transferred. • FALSE: The jerk time is not being transferred at present. Error BOOL This output shows whether an error as occurred in the function module. • TRUE: An error has occurred during the transfer of the jerk time. • FALSE: No error has occurred. ErrorID DWORD This output displays the error code of the error (→ page 68). Axis AXIS_REF This output displays the axis reference. Note: The function module MC_SetJerk_MDX changes the ramp type of the drive inverter from a linear ramp to a jerk-limited ramp. For speed-controlled travel tasks, the drive inverter automatically uses a linear ramp. When the drive inverter then executes a positioning task, it automatically switches back to the jerk-limited ramp. If you set the JerkTime input to 0, the function module MC_SetJerk_MDX switches the ramp type back to linear again. Manual – MPLCMotion_MDX Library 57