Download USER MANUAL

SATEL
INTEGRA
Button 4
assign function to keyfob button 4
assign function to combination of keyfob buttons 1 & 2
Button 1 and 2
assign function to combination of keyfob buttons 1 & 3
Button 1 and 3
set event generating rules
Events (RX)
add keyfob supported by ABAX system
New ABAX keyfob
remove keyfob supported by ABAX system
Rem.ABAX keyfob
Button 1
assign function to keyfob button 1
assign function to keyfob button 2
Button 2
assign function to keyfob button 3
Button 3
assign function to keyfob button 4
Button 4
assign function to keyfob button 5
Button 5
assign function to combination of keyfob buttons 1 & 5
Button 1 and 5
set event generating rules
Events (ABAX)
set confirmation rules
Confirm. (ABAX)
set master name
Name
Edit master
edit existing master
[select master]
[list of parameters identical as in case of a new master]
Remove master
remove master
Zone bypasses
Inhibit
temporary zone bypass
permanent zone bypass
Isolate
set control panel clock
Set time
System state
check troubles / check system state
Events
Selected
Select events
select type of events to be viewed
select partitions from which events are to be viewed
Select part.
view selected events
View
View Grade2
view events required for Grade 2
All
view all events
view events required for Grade 2
Grade2
Reset zones
reset 43. RESETABLE POWER SUPPLY type outputs
clear latched outputs
Clr.latch.outs
end door fire opening
Fin.f.door open
Change options
Keypad chime
enable/disable CHIME in keypad
block zone violation signal. on 11. CHIME type outputs
Outputs chime
Timers
edit timers
Part. timers
program partition timers
No exp.tamp.al.
block expander tampers
enable/disable permanent installer access
Perm.serv.accs.
Serv. can edit
make user editing available to installer
Serv. ArmDis...
make system control available to installer
Perm.DloadX acc
enable/disable permanent DLOADX access
DloadX IP
set address of computer with DLOADX program
set address of computer with GUARDX program
GuardX IP
erase service note
Erase s.message
Tests
Partitions
check current state of partitions
check current state of zones
Zones
Supply voltages
check module supply voltage
13