Download USER MANUAL

SATEL
INTEGRA
33
6. Using the  and  keys, find in the list the partition for which the timer is to be
programmed.
7. Press the key.
8. When the ACTIVE option is displayed, make sure it is enabled (the symbol is displayed
next to the option). If it is not enabled (the symbol is displayed next to the option), press
any digit key.
9. Using the  key, scroll through the menu until you find the TYPE function.
10. Press the key.
11. Using the  and  keys, select the timer type:
everyday – if the partition is to be armed / disarmed at the same time every day;
weekly – if the partition is to be armed / disarmed at different times on different days of
the week.
12. Press the key.
13. If you have selected the daily variant, the function will allow you at once to program the
arming time, and upon pressing the  or  key – the disarming time. Upon confirmation
with the key, you will be brought back to the list of options and functions.
14. If you have selected the weekly variant, you will be brought back to the list of options and
functions, where functions will appear to enable programming of the arming / disarming
time for each day of the week (in the same way as for daily timer).
Programming the value 99:99 means that the partition will not be armed / disarmed.
15. After the arming time has been programmed, an additional function will be displayed,
which allows you to define which arming mode will be activated by the given timer. By
default, the timer activates the full arming mode. If another arming mode is to be
activated, run this function (for the daily timer or individually for each day of the week)
and, using the  and  keys, select another arming mode. Confirm, using the key.
16. Having programmed all parameters, press the
key.
17. When a prompt appears, asking you if the changes are to be saved, press the 1 key.
5.13 Zone testing
Within periodic inspections of the security alarm system, the detectors must be checked for
proper functioning. The zone testing function will allow you to do it without triggering the
reaction normally expected on violation, which is of particular importance in case of
permanently armed zones.
1. Enter the code and confirm with the
key.
2. Using the  key, scroll through the menu until you find the TESTS submenu.
3. Press the key.
4. Using the  key, scroll through the menu until you find the ZONES TEST submenu.
5. Press the key.
6. When the NEW function is displayed, press the key.
7. Select whether burglary zones or fire and technical zones will be tested, and then press
the key.
8. Select the partitions in which zones will be tested (see: section SELECTION FROM THE
MULTIPLE-CHOICE LIST p. 15).
9. Specify the test duration (maximum 50 minutes) and press the key.
10. Define, whether violation of a zone is to be signaled by chime in the keypad (the signaling
will be enabled upon pressing any digit key – the symbol will be displayed).