Download MEGAPLEX-2100 MODULE

Transcript
Quick Start Guide
If you are familiar with the VC-6 module, use this guide to prepare it for operation.
Preliminary Preparations
VC-6/FXS and VC-6/FXO modules do not require any internal settings.
For VC-6/E&M modules, select the required signaling mode referring to figure
below.
Type I
Type II
Type III
SSDC5
SW1
ON
ON
ON
OFF
SW2 SW3
ON ON
OFF ON
ON ON
OFF OFF
ON
SW1
SW2
OFF
SW3
Connecting the Cables
Order from: Cutter Networks
Insert the VC-6 module in the assigned slot of the Megaplex enclosure and then
connect voice channels as follows:
•
VC-6/E&M modules – use an adapter cable to connect the voice channels to
the module TELCO connector.
•
VC-6/FXS and VC-6/FXO modules – connect the voice channels directly to the
module RJ-11 connectors.
Connect the -48 VDC external feed voltage, if required.
1
Ph:727-398-5252/Fax:727-397-9610
www.bestdatasource.com