Download PIR Detector with Camera - Image Capture

Transcript
GB
IMPORTANT
• During recognition programming, the detector does not need to be
placed close to the control panel. In fact, we advise you to place it at
least 2 metres away.
• The detector must be programmed for immediate triggering
for image sequences to be recorded and transmitted when intrusion
occurs.
1. To perform detector recognition programming, the control panel
must be in installation mode. If it is not, ask the user to enter:
“beep,
installation mode”
master code (factory: 0000)
then
installer code (factory: 1111)
2. Perform the following recognition programming sequence:
“detector X”
“group”
“time delay?”
“beep,
detector X,
group Y,
immediate”
)))
))
to
then
10 s max.
Press ‹ then
# on the
control panel
keypad
Press and hold
the “test”
button until the
control panel
responds
Select a group
from 1 to 8.
Use the
control panel
keypad to do
this.
Programme the
detector for
immediate
triggering.
Use the control
panel keypad
to do this.
The
control panel
confirms
recognition
programming
and the red
LED on the
detector lights
up twice
for 2 s.
The control panel issues three short beeps to indicate a
programming error. When this happens, perform programming
again from the start.
98