Download - FOSS AS

Chapter 4
Reflectometry measurements
4
Pressing the START/STOP key is all that is needed to start or stop a
measurement. However, it is necessary to configure the measurement
and the type of results desired.
This chapter describes the different stages in a reflectometry measurement made using an OTDR plug-in and the OTDR function of a 5083CD
plug-in.
The topics discussed in this chapter are as follows:
–
“Selecting the function” on page 44
–
“Configuring the reflectometry test” on page 44
–
“Acquisition” on page 51
–
“Trace display functions” on page 56
–
“Events” on page 57
–
“Table of results” on page 59
–
“Automatic measurement and detection” on page 64
–
“Addition of markers” on page 65
–
“Manual measurements” on page 66
–
“Memorization of the position of events” on page 71
–
"Fault Locator Mode" on page 72
–
“File Management” on page 75
User Manual
780000102/09
43