1
Download "user manual"
Transcript
Introduction to NX7/70 Series PLCs 2) Check to make sure that the Program/Remote/Run switch is set to Remote (RMT). Refer to section 2 of the previous picture. NOTE: Remote Mode allows WinGPC to control the RUN/PROGRAM mode of the controller, instead of using this switch. 3) Check to make sure that the RS-232 serial cable is connected from the PC to the NX controller in the Demo Kit. 4) Check to make sure the Demo Kit is powered up. 30 of 31 Publication OEMax-NX70-LB001A-EN-E - March 2005
