Download CFI User Manual - AuCom Electronics

GENERAL DESCRIPTION
SECTION 2
DEFINITIONS & DESCRIPTIONS
Overview : This section provides overview of terms used in this manual.
Content : Abreviations and Terminal Names .......................................................
Software Control Input ........................................................................
Software Control Output .....................................................................
Parameter Overview .............................................................................
2-1
2-1
2-1
2-2
Abbreviations &
Terminal Names
SYMBOL
DESCRIPTION
TYPE
ATN
Frequency Attained
Software Control Output
C SEL
Ramp Selection
(Primary/Secondary)
Software Control Input
COM
Analogue Input Terminal Common
Analogue Input
EMS
Emergency Stop
Relay Input
F.JOG
Forward Inching
Software Control Input
F.RUN
Forward Run
Relay Input
FC,FA,FB
Relay Outputs
Relay Output
FDW
Frequency Down
Software Control Input
FLT
Trip (Fault)
Software Control Output
FSI
4-20mA Speed Signal Input
Analogue Input
Ftrq
Supply Frequency
FSV
0-10VDC Speed Signal Input
FUP
Frequency Up
Software Control Input
HOLD
Hold (Latch)
Software Control Input
I DET
Current Set Point [B26-1] Reached
Software Control Output
IFS
Use IFS Speed Signal
Software Control Input
MC
Precharging In Progress
Software Control Output
P10
10V Source For FSV
Analogue Output
PROG
Activate Multi-Step Function
Software Control Input
PSI1
Programmable Input 1
Relay Input
R.JOG
Reverse Inching
Software Control Input
R.RUN
Reverse Run
Software Control Input
RDY
Ready
Software Control Output
REV
Reverse
Software Control Output
RST
Fault Reset
Relay Input
RUN
Run
Software Control Output
S0, S1
Selector Switches For Multi-Step &
Pattern Run
Software Control Input
SPD
Speed Set Points Reached
Software Control Output
VFS
Use FSV Speed Signal
Software Control Input
Analogue Input
Software Control Input :
An internal input parameter which can be assigned to one of the DSC
programmable Input Terminals, or permanently programmed to be ON or
OFF.
Software Control Output :
An internal output parameter which can be assigned to one of the DSC
programmable Output Terminals.
CFI SERIES
2-1
USERS MANUAL