1
Download Fagor
Transcript
12.5 SURFACE MEASURING CANNED CYCLE A probe placed in the spindle will be used, which must be previously calibrated by means of canned cycles: Canned cycle for calibrating tool length. Canned cycle for calibrating probe. This cycle allows correcting the value of the tool offset of the tool which has been used in the surface machining process. This correction will be used only when the measurement error exceeds a programmed value. The programming format for this cycle is: (PROBE 3,X,Y,Z,B,K,F,C,D,L) X+/-5.5 Theoretical coordinate, along the X axis, of the point over which it is required to measure. Y+/-5.5 Theoretical coordinate, along the Y axis, of the point over which it is required to measure. Z+/-5.5 Theoretical coordinate, along the Z axis, of the point over which it is required to measure. B5.5 Defines the safety distance. Must be programmed with a positive value and over 0. The probe must be placed, with respect to the point to be measured, at a distance greater than this value when the cycle is called. Chapter: 12 WORKING WITH A PROBE Section: SURFACE MEASURING Page 11
