1
Download Fagor
Transcript
Basic operation: 1 6 5 7 Z 2 9 3 Y X Z Z B B 2 B B 5 3 9 7 Y B B X B B 1.- Positioning over the center of the boss. Movement of the probe in rapid (G00) from the point where the cycle is called to the center of the boss. The approaching movement is made in two stages: 1st Movement in the main work plane. 2nd Movement along the longitudinal axis up to a distance (B) from the programmed surface. 2.- Movement to the first approach point This movement of the probe which is made in rapid (G00) consists of: 1st Movement along the ordinate axis. 2nd Movement of the longitudinal axis the distance (2B). Chapter: 12 WORKING WITH A PROBE Section: BOSS MEASURING Page 33
