Download Svantek - Supervisor Software Manual

data’ corresponds to all the available time history, ‘inside blocks’ correspond to the
accumulated ranges of all block selections, ‘outside blocks’ correspond to the ranges of
all the fragments of the time domain which are not included in block selections, and
‘individual blocks’ correspond to separate block selections, displayed individually (as
Block 1, Block 2 etc.).
Use the commands in this
menu to customize the
contents of the table.
Click with the right mouse button anywhere
in the table area to open the context menu.
Fig.4-39 Context menu for customizing the contents of the table below the plot.
Export modes
You can export the plotted results in two modes:
 the ‘single’ mode, represented by the
icon, consists in exporting a single figure,
containing only the range of the time history displayed in the panel.
 the ‘multi (screen-by-screen)’ mode, represented by the icon, consists in exporting all
the time history in several figures.
The two modes are illustrated in Fig.4-40. In order to change the mode, use the
/
buttons, located at the bottom-left corner of the panel.
© SVANTEK
- 60 -
Supervisor User Manual