Download Blaine Elementary School

Transcript
Blaine Elementary School
(Replacement)
Walton County, GA
B.
1.08
1.09
At the completion of the building, the Contractor shall furnish and deliver to the Owner,
Certificates of Approval from the local inspecting authority for the National Board of Fire
Underwriters and other agencies having authority, indicating approval of the electrical work
installed under the contract.
SHOP DRAWINGS
A.
Shop drawings and/or catalog data on all items of equipment and materials shall be
submitted in conformity with requirements of the General and Supplementary Conditions.
The responsibility of complying with the Contract Documents shall not be relieved by the
Engineer's review of shop drawings.
B.
The submittal shall include a list of the manufacturers of the principal items of material: wire,
conduit, connectors, devices, boxes, lighting fixtures, special systems, panelboards,
switchboards, etc.
C.
Specified catalog numbers and trade names are intended to describe the material, devices,
or apparatus desired. Similar materials of other manufacturers, if of equal or equivalent
quality, capacity and character may be substituted in conformity with provisions of the
General and Supplementary Conditions.
D.
Samples of all materials proposed for use shall be presented to the Architect for his approval
when requested.
ELECTRICAL SERVICES TO EQUIPMENT
A.
Following equipment shall be furnished and installed under other Sections of this manual:
1.
2.
3.
4.
5.
6.
7.
8.
1.10
Finishing Hardware
Projection Screens
Special Equipment
Food Service Equipment
Casework
HVAC Equipment
Water Heaters
Automatic Controls
Section
Section
Section
Section
Section
Section
Section
Section
08700
11300
11300
11450
12300
15060 & 15600
15400
15275
B.
Contractor shall coordinate and determine the electrical requirements of all equipment
(whether included in above list or not) furnished under other Sections.
C.
Contractor shall provide power wiring, conduit, disconnect switches, junction boxes as may
be required for equipment furnished under other sections of this specification. Make all final
hook-ups and connections.
D.
Contractor shall carefully review all portions of the documents, so as to become aware of the
scope of the work required by this section.
MATERIAL, WORKMANSHIP, AND PROTECTION
A.
Material and apparatus of the latest and best design and manufacture shall be installed to
provide complete electrical systems. Experienced mechanics of proper trades shall perform
work and work harmoniously with all other trades. All work, material, fixtures, apparatus, etc.,
shall be protected from injury or damage and delivered clean. All cutting and channeling
shall be accomplished in a neat and workmanlike manner without removal of excess
materials. Patch and replace all cut and channeled areas with material similar to adjacent
construction.
16010-3
Electrical General Provisions