Download CLASS Diagnostic Software

CLASS 3 (50330055)
13
See Parameters Window 10 for control location.
5.2.2.7
Programmed Target Values
Clicking on Get Programmed Targets will get any existing programmed fixed target
values from the controller and insert those values in the LPS, MSU, and RPS
Programmed Target Values boxes as appropriate. Note these values will NOT include
any un-programmed targets seen at turn-on.
See Parameters Window 10 for control location.
5.2.3
Modes
5.2.3.1
TempComp Mode
When enabled, TempComp Mode enables the CLASS™ system to improve its
accuracy by measuring the temperature of the air near its sensors. Use of this mode
requires that a "cooperative object" (a fixed object whose distance to the sensor is
accurately known) be available for each sensor and its distance from the sensor be
entered in the second box of the sensor's fixed objects table.)
See General Notes
11
for target placement when using this mode.
See Parameters Window 10 for control location.
5.2.3.2
Snow Mode
When enabled, the Snow Mode provides a way for CLASS™ to dynamically reduce its
sensitivity to help deal with a target that occurs after turn-on calibration, such as that
which might occur due to a build-up of wet snow on the door panels.
See also Open Limit Timer 3 (Snow Mode)
21
and Door Recycle Limit (Snow Mode)
21
.
See Parameters Window 10 for control location.
See CLASS™ 3 Theory of Operation (TB08-05-096) for a more detailed explanation of
Snow Mode and its parameters.
5.2.3.3
Relay Mode
Relay Mode is used on buses whose doors are not controlled by a bus computer or
PLC. When enabled, it ensures that the Door Open Command will remain active at least
until the door reaches fully open.
See also: Hold Open Timer 1 (Relay Mode) 20
© 2003-2010 Vapor Bus International