Download FX-TRN-BEG-E USER`S MANUAL
Transcript
FX-TRN-BEG-E 3.1.3 Operation 3 Application instruction The following is how to input application instructions. The MOV instruction and the LD= instruction are explained up as examples. • MOV instruction 1) Place the cursor where the MOV instruction is to be written. Press the [F8] key. The ’Enter symbol’ dialog box is displayed. Type MOV K100 D0. 2) Click the [OK] button. Write the MOVP instruction and the DMOVP instruction as follows. MOVP instruction DMOVP instruction • LD= instruction 1) Place the cursor where the LD= instruction is to be written. Press the [F8] key. The ’Enter symbol’ dialog box is displayed. Type LD= K100 D20. Both capital letters and small letters can be used. 2) Click the [OK] button. POINT For the list of available instructions and input procedures, refer to the Appendix 1. C-14