Download TEMP05 User Manual

midon design
TEMP05 Commands
Table 1. Commands Available
Command
CRC
DIS
EEP
ERA
GET
HLP
HUM
INI
MEM
NOR
ONE
QTY
REV
RLB
Description
Check all device checksums
Display serial numbers of all
configured One-Wire devices
Display and change specific
EEPROM memory locations
Erase the EEPROM
Obtain and display wind and rain.
Display a list of available commands
Request and display humidity sensor
readings
Search for a list of available
DS18S20's and rain gauge
Display and change specific memory
locations
Set North for a One Wire Weather
Station
Begin receipt of a Dallas
Semiconductor V1 One Wire Weather
Station INI.TXT file
Display a count of DS18S20 Sensors
Will reverse the wind direction to
compensate for a reversed board in a
One Wire Weather Station. North will
stay N, and South will stay S, but East
will become W, West will become E,
etc.
Actuate all relays at once
RLT
Set the relay off timer. This timer will
turn off all relays y minutes after the
last RLYxOn command.
RLY
Actuate a specific relay
RST
SET
Reset the Rain Gauge counter
Configure the interval and F/C display
TEMP05 User Guide Version Hb
Syntax
CRC
DIS
Available in
V4.14 or higher
EEP <start location>
all
ERA
GET
HLP
HUM
all
all
all
V4.14 or higher
INI
all
MEM <start location>
all
NOR
V4.17 or higher
ONE
all
QTY
REV
V4.15 or higher
V4.18 or higher
RLB x where x = an 8
bit binary number
representing all
relays. The MSB is
relays 8 and a 1 turns
on a relay.
RLT
You will be prompted
for the relay timer
value in decimal
minutes.
RLY <relay number>
<on|off>
where <relay
number> = 1 to 8 or
A for All.
V4.17 or higher
RLY S (displays
status of all relays)
RST
SET
all
V4.18 or higher
all
all
all
Page 5 of 9