Download GT01 Technical Manual

Connecting and Communicating with the PLC
GT series
4.6
4.6
Through Function
Through Function
With the GT series, communication can be set to take place automatically between the
COM. and TOOL ports in a “through function”. When the FP series tool software
installed in the computer connected to the GT series as shown below is booted, PLC
programs can be edited through the GT series.
The through function does not require any special settings, and is always in the standby
mode.
PLC
GT01
Connected by cable
to the TOOL port of
the PLC
PLC debugging
The FPWIN GR can booted on the computer being used to edit the GT series
screens, and the PLC programs can be
edited and monitored through the GT
series.
Screen
transfer
cable
AFC8503
Screen data
being sent
and received
Screen creation tool GTWIN
FP series programming tool FPWIN GR
Personal computer
35