Download Multicam 14 Installation Guide

Transcript
INSTALLATION MANUAL Multicam 14.00
3.
Exploring the Startup Menu
3.1.
Overview of the Startup Menu
When booting the EVS server after a Multicam 14 installation, the following startup menu
is displayed each time:
3.2.
•
If you want to boot the Multicam 14, highlight option <1> and press Enter.
•
If you want to enter the Maintenance menu, highlight option <2> and press Enter.
•
If you want to display contact and support information, highlight option <3> and press
Enter. See section "Support & Contact Information" on page 14.
Boot Multicam 14
If this option is selected, the system boots the version that is currently active. The initial
boot menu will proceed after 5 seconds if the user does not press a key.
3. Exploring the Startup Menu
15