Download RoboLab Reference Guide - Utah State 4-H

Transcript
331
Peak
Time
Peak time is the time between two wells (wells
are defined as values below a threshold or
cutoff value). Use this command to determine the
amount of time between peaks (above the cutoff
value) of a data set. If you have multiple peaks
on your graph, this command will return a graph
of the well times between each one. Useful for
measuring for time between touch sensor presses
or light sensor spikes.
Example
This piece of code creates a graph of all the peak times
above the cutoff value for the red data set and plots it in
the purple bin.
LEGO, the LEGO logo and MINDSTORMS are trademarks of the LEGO Group.
© 2006 The LEGO Group.
This page may be photocopied for non-commercial educational use.
All other rights reserved.
Visit www.MINDSTORMSeducation.com & www.LEGOengineering.com