Download pdf manual
Transcript
SuperTrak SX6000™ User Manual Appendix A A. SuperTrak SX6000 Technical Specifications Performance-Related Features • • • • • • • • • • • • True hardware-based RAID Single IRQ per RAID I/O Intelligent cache dynamically configures itself Support for up to 128MB (minimum of 16MB required) of RAM in one 168-pin DIMM socket Microprocessor offloads tasks to reduce system CPU utilization User-configurable cache parameters for each array: write policy, and flush policy User-configurable RAID stripe sizing allows controller to optimize operations for operating systems and applications Multi-threaded command processing and disk operations Supports Tagged Command Queuing for optimal disk performance Advanced load balancing and elevator seek for optimal disk performance Hardware scatter gather DMA engine reduces CPU overhead Intelligent algorithm to optimize RAID 5 writes Data Protection Features • • • • • • • • Support for RAID levels 0, 1, 0+1, 3, 5 and Spanning Meets all of the RAID Advisory Board’s standards for RAID levels Automatic failed drive detection and transparent disk drive rebuild Onboard buzzer sound audible alarms in the event of failure Supports S.M.A.R.T. capable drives for predictive failure analysis messaging through PAM GUI Hot swap capability Hot spare capability Configuration is stored on all disks in the array. This allows configuration to be restored to a new controller in case of controller failure Host Interface • • • • • • • • • On board 32-bit Intel i960RM RISC microprocessor I2O version 1.5 compliant Supports up to 33MHz PCI bus speed Supports up to 133MB per second burst data transfer rate across PCI bus Provides 32-bit PCI bus mastering with 0 wait states. PCI Local Bus version 2.2 compliant Onboard 64K Flash BIOS Firmware Flash EEPROM NVRAM for error log for fast recovery - A1 -