Download pdf manual

Transcript
SuperTrak SX6000™ User Manual
Appendix A
A. SuperTrak SX6000 Technical Specifications
Performance-Related Features
•
•
•
•
•
•
•
•
•
•
•
•
True hardware-based RAID
Single IRQ per RAID I/O
Intelligent cache dynamically configures itself
Support for up to 128MB (minimum of 16MB required) of RAM in one 168-pin
DIMM socket
Microprocessor offloads tasks to reduce system CPU utilization
User-configurable cache parameters for each array: write policy, and flush
policy
User-configurable RAID stripe sizing allows controller to optimize operations for
operating systems and applications
Multi-threaded command processing and disk operations
Supports Tagged Command Queuing for optimal disk performance
Advanced load balancing and elevator seek for optimal disk performance
Hardware scatter gather DMA engine reduces CPU overhead
Intelligent algorithm to optimize RAID 5 writes
Data Protection Features
•
•
•
•
•
•
•
•
Support for RAID levels 0, 1, 0+1, 3, 5 and Spanning
Meets all of the RAID Advisory Board’s standards for RAID levels
Automatic failed drive detection and transparent disk drive rebuild
Onboard buzzer sound audible alarms in the event of failure
Supports S.M.A.R.T. capable drives for predictive failure analysis messaging
through PAM GUI
Hot swap capability
Hot spare capability
Configuration is stored on all disks in the array. This allows configuration to be
restored to a new controller in case of controller failure
Host Interface
•
•
•
•
•
•
•
•
•
On board 32-bit Intel i960RM RISC microprocessor
I2O version 1.5 compliant
Supports up to 33MHz PCI bus speed
Supports up to 133MB per second burst data transfer rate across PCI bus
Provides 32-bit PCI bus mastering with 0 wait states.
PCI Local Bus version 2.2 compliant
Onboard 64K Flash BIOS
Firmware Flash EEPROM
NVRAM for error log for fast recovery
- A1 -